WARNING
This transmitter should never be operated without a suitable antenna or test dummy
load! Failure to observe this requirement may result in damage to the transmitter
that is not covered by the warranty.
IMPORTANT
This transmitter has been shipped with the internal stereo generator enabled. The
internal jumper J5 (MPX loop-through) is set to ON.
If you intend to connect a MPX signal to the MPX input
BNC connector you will need to move J5 (MPX loop-
through) to the OFF position.
Examples of congurations requiring setting J5 to OFF
include:
● Routing the internal MPX signal through an external RDS encoder.
● Connecting an external audio processor or stereo generator to the
transmitter.
● Connecting a re-broadcast or STL receiver to the transmitter.
Consult the manual for further information on the transmitter’s jumpers and con-
nections.
MPX Loopthrough Jumper
in off position
To Next Page
Loading...
