BWT PERMAQ compact 4 - Page 39

EN
39
Fig. 13: Programming procedure: CONDUCTIVITY / TDS (Electric conductivity value/Total Dissolved Solids)
SET METER
SET LIMIT
BACK
PASSWORD
_ _ _ _ _ _
PW: *** ***
CONDUCTIVITY LIMIT
200 μS
DISABLE
CONDUCTIVITY LIMIT
100 μS
DISABLE
CONDUCTIVITY LIMIT
100 μS
DISABLE
CONDUCTIVITY LIMIT
100 μS
ENABLE
SET METER
SET LIMIT
BACK
*EC (μS)
TDS (ppm)
BACK
*EC (μS)
TDS (ppm)
BACK
EC (μS)
*TDS (ppm)
BACK
EC (μS)
*TDS (ppm)
BACK
SET METER
SET LIMIT
BACK
PASSWORD
_ _ _ _ _ _
PW: *** ***
TDS LIMIT
20 ppm
DISABLE
TDS LIMIT
35 ppm
DISABLE
TDS LIMIT
35 ppm
DISABLE
TDS LIMIT
35 ppm
ENABLE
DATE / TIME
CONDUCTIVITY / TDS
OPERATION MODE
LANGUAGE
BACK
Setting range:
„CONDUCTIVITY LIMIT“ 40 ... 200
μS
» incremental steps « : [+/-10 μS]
Setting range:
„TDS LIMIT“ 20 ... 100
ppm
» incremental steps « : [+/-5 ppm]
Fig. 12
Fig. 14
Fig. 14 ... to call up: OPERATING MODE
PASSWORD:
When the blending is actively set, then the
limit value for “conductivity/TDS limit” must
be increased accordingly the requirements.