BWT Vida - Handling Instructions; Initial Operation and Filter Cartridge Change

EN
23
6. Handling Instructions
6.1 Initial operation and lter cartridge change
Prior to the rst use or when changing the exhausted lter cartridge: clean
jug, funnel and lid of the BWT water ltering system with a detergent and rinse
thoroughly with warm water. Do not use any abrasive cleaning agents or scrub-
bing sponges, as scratch marks could be left on the BWT water ltering system.
Jug and funnel can be washed in the dishwasher. The lid may not be washed in
the dishwasher.
In order to achieve best possible ltration performance, we recommend you to
put the new lter cartridge in tap water for 5 minutes. After that please discard
the water.
Subsequently insert the new lter cartridge into the funnel of the water ltering
system by pressing it in lightly into place.
If the BWT water ltering system is equipped with the automatic lling system
„Easy-Fill“ in the lid, it is not necessary to take off the lid when lling the jug.
The „Easy-Fill“ system opens automatically, when the water jet meets the ope-
ning and closes automatically after lling.
Discard the rst ltered water lling and rell the BWT water ltering system.
Fine black particles of activated carbon could be ushed out, which are,
how ever, completely harmless. In this case we recommend to rell the jug and
discard the water again until it is clear and free from particles.
The BWT water ltering system is now ready for use.
1
2
3
4
5
6
2 3 4 5 61