What to do if my BWT Perla Silk S Water Dispenser electronic display shows error code “SALt”?
If your BWT Water Dispenser's display shows the error code “SALt” and an audible alarm sounds, fill the brine cabinet with salt. Then, press the [SET] key to reset the salt alarm to the full capacity of salt.
What to do if my BWT Water Dispenser electronic display shows error code “Err 1”?
If the display shows error code “Err 1” and an audible alarm sounds, check that all the connections are secure. Turn the power off for 15 seconds until PF is no longer displayed, then turn it back on to allow the system to reset.
Why does my BWT Water Dispenser unit regenerates at the wrong time?
If your BWT Water Dispenser regenerates at the wrong time, check if the present time is correct and reset it if necessary.
What to do if my BWT Water Dispenser water level in brine cabinet reaches overflow?
If the water level in your BWT Water Dispenser's brine cabinet is overflowing: * Check if the line pressure is within the water softener's specification by connecting a pressure gauge to a water outlet. Ensure the pressure is between 1.7 - 5.0 bar for UK. * If the pressure falls outside the specification, fit a pressure reducing valve or booster pump. * Inspect the drain line to ensure it is not kinked, blocked, or frozen. * Verify that the power is on and all connections are secure.
What to do if my BWT Water Dispenser water runs from the drain constantly?
If water runs from the drain constantly: * Check if the unit is in recharge mode. If it is, this is normal; wait until the recharge is complete. * Ensure the power is on and all connections are secure. If using battery operation, change the battery.
How to fix excessive salt usage in my BWT Perla Silk S?
To address excessive salt usage in your BWT Water Dispenser, check the hardness setting and reduce it if it is incorrect.
What to do if there is no water from my BWT Perla Silk S?
If there is no water coming from your BWT Water Dispenser: * Open the mains stop valve. * Open the inlet and outlet valves to the water softener or operate uniconnect.
How to fix hard water from my BWT Perla Silk S?
To resolve the issue of hard water from your BWT Water Dispenser: * Fill the brine cabinet with salt. * Switch the power on and check connections. For battery operation, change the battery. * Close the by-pass valve and open the inlet and outlet valves or operate uniconnect. * Reset the hardness if required.
Covers electrical safety, protection from extreme temperatures, and general warnings for safe operation.
Describes the pre-set values for time, regeneration, and hardness for optimal initial performance.
Guides users through setting the time of day, water hardness, and recharge time.
Details environmental conditions, water pressure, and national guidelines for proper installation.
Covers handover to the operator, checking connections, and initial setup steps.
Provides detailed instructions for positioning, connections, drain, electrical, salt filling, and blending.
Outlines essential tasks for maintaining the softener's functionality, including salt and leak checks.
Provides solutions for common problems such as hard water, overflow, and no water supply.
General| Brand | BWT |
|---|---|
| Model | Perla Silk S |
| Category | Water Dispenser |
| Language | English |
To Next Page
