What to do if my BWT Bewamat 25A unit is not supplying softened water or the flow is insufficient?
If your BWT Water Dispenser isn't supplying enough softened water, the inlet pressure might be too low. Increase the inlet pressure, setting the pressure reducer if necessary, and then start manual regeneration.
What to do if my BWT Bewamat 25A is not supplying softened or blended water?
If your BWT Water Dispenser isn't supplying softened or blended water, it could be due to several reasons. First, check if the regenerative salt storage is empty and refill it, then press the OK button until the SALt display disappears. Allow three hours for the brine to form and then initiate a manual regeneration. Also, ensure that the power supply is properly connected. Finally, verify that the blending adjusting spindle is correctly set as outlined in the start-up section for setting blended water hardness.
Why does my BWT Bewamat 25A display 'SALt'?
If the display on your BWT Water Dispenser indicates 'SALt', it means there is insufficient regenerative salt in the storage area or the pipeline pressure is too low, leading to inadequate suction speed. To resolve this, refill the regenerative salt and press the OK button until the 'SALt' display turns off. Acknowledge the fault by pressing the OK button. If the issue persists, it is recommended to contact after-sales service.
Why is the flushing water coloured at start-up of my BWT Bewamat 25A?
The coloured flushing water at the start-up of your BWT Water Dispenser is due to abrasion particles from the exchanger resin. To resolve this, repeat the start-up flush.
Why is my BWT Water Dispenser not supplying softened or blended water?
Your BWT Water Dispenser might not be supplying softened or blended water due to several reasons: There may be no regenerative in the storage area. The power supply could be interrupted. Or the blending adjusting spindle might not be set correctly. Refill the regenerative, then press the OK button until the SALt display goes out. Wait three hours for the brine to form and start manual regeneration. Make sure that the electrical connection is established. Set the blending adjusting spindle as described in the Start-up section 'Setting the hardness of blended water'.
What to do if SALt is indicated on the display of my BWT Bewamat 25A?
If 'SALt' is indicated on the display, it means there is insufficient regenerative in the storage area or insufficient pipeline pressure resulting in insufficient suction speed. Refill the regenerative and press the OK button until the SALt display goes out. Press the OK button to acknowledge the fault. If the fault occurs again, contact after-sales service.
Why is there coloured flushing water at start-up of my BWT Bewamat 25A?
Coloured flushing water at start-up is due to abrasion particles of the exchanger resin. Repeat the start-up flush to resolve this.
General safety instructions and legal compliance.
Highlights critical safety warnings specific to the product.
Specifies that only trained professionals should perform installation.
Detailed steps and considerations for physically installing the unit.
Explains the keypad functions and display for unit control.
Instructions for filling and preparing the brine for operation.
Procedure to adjust water hardness to desired levels.
Guidance on replenishing the salt (regenerative) supply.
General| Brand | BWT |
|---|---|
| Model | Bewamat 25A |
| Category | Water Dispenser |
| Language | English |
To Next Page
