CC Skywave Page 15
Radio Operation
the 9/10 kHz button for two seconds with the radio turned OFF. When tuning steps are set to 9 kHz the FM
Band will also be expanded to cover 76-108 MHz (FM band in Japan).
15. Alarm Button\Setting the Alarm
With the alarm powered o, press and hold the ALARM button
for two seconds. While the hour is
ashing, press the or tuning buttons (or rotate knob) until the hour and AM/PM time is correct. Press
the ALARM button again to adjust the minutes. When nished, press the ALARM button again to conrm. To
disable alarm, press the ALARM button for three seconds. By default, the alarm will wake you with a beep.
To wake to a radio station, press the #5
button during alarm setup. A speaker icon displays on the
screen indicating that the alarm will wake to the previous radio station played. It is best to check the station
frequency and adjust the volume level to your wake up preference before going to sleep to insure that is just
how you want it. When the alarm sounds, press the power button to turn the alarm o, or press any other
button to sleep for 10 more minutes.
16. FM/WX/AIR/SW - Positioning the Whip Antenna
Flip up and fully extend the whip antenna. For most stations, reception is best when antenna is positioned
vertically. Other stations may have better reception with the antenna positioned dierently.
17. Tuning Knob
Rotate knob to tune to the next frequency increment. Press the knob “IN” towards the body of the radio (once
quickly) to change between “FAST” and “SLOW” tuning increments when rotating the knob. “FAST” tuning will
use larger incremental steps between frequencies. “SLOW” tuning can improve AM stations that are slightly
V A
To Next Page
Loading...
