designing the back barrier, please remember that a person must access the back for
maintenance and cleaning.
2.5. Powering On GreenFeed
Once the system is in place and secure, powering on the system is simple.
● For freestall and tie-stall systems, simply plug in the power cord to a standard AC
outlet (110V ~ 220V, 50 ~ 60Hz). Ensure your power cable is routed in a way that
prevents animals from accessing it.
● For pasture trailer systems, the power switch is located in the battery box. See the
GreenFeed Pasture Trailer Setup playlist - Trailer Walk Around video for instructions
(https://videos.c-lockinc.com)
Once the system is powered on, please allow at least 30 minutes for the concentrations to
“warm up” and equilibrate. Calibrations, CO
2
Recoveries, and animal measurements done
before the 30 minute warm-up time may not be valid.
2.6. Powering Off GreenFeed
To power off the system, please follow the steps in Section 3.2 part 6b (turn the system off).
Once the system is commanded to shut off, please wait 30 seconds before unplugging the
power. This will allow enough time for GreenFeed to save its data and full power down.
To Next Page
Loading...