CHANGING MODES
Switching from one mode to another is done by operating the trigger switch (O in diagram 7). Away
from the body to select MOTION and central to select NON MOTION.
OPERATING IN MOTION MODE
Push the trigger switch forward to select MOTION mode and turn the SENSITIVITY to the
highlighted area. Your CS4ZX, in MOTION mode, is now ready to use.
DISC
Discrimination allows the user to ignore certain metals whilst still finding others. DISC does
not allow individual metals to be ignored but rather a range. In the ALL METAL position
nothing is ignored. Turning the DISC control on at its lowest setting, the detector ignores
small iron objects but still detects the more valuable metals. Increasing the setting still further
and the detector will also ignore aluminium foil. Beyond this setting some valuable items will
begin to be rejected. Operating at a disc setting of ten rejects silver and nickel coins. A
recommended setting of five is highlighted at which iron and small pieces of aluminium foil are
ignored but most valuable items are still detected.
Diagram 10 Effect of Discriminate Control Position
NOTCH
NOTCH is a variation of the DISC control which allows individual targets to be ignored, or
with the REJECT/ACCEPT switch in ACCEPT, detected and all others ignored. NOTCH
should only be used where specific items such as ring pulls are causing a nuisance as the
response to some valuable items is affected.
To set the detector to ignore ring pulls first make sure the ACCEPT/REJECT switch is set to
REJECT and DISC is in ALL METAL (off). Sweep the ring pull across the head whilst
£1 COIN
RING PULL
NAIL
HORSESHOE
5p COIN
CIGARETTE
PACKET
MILK
BOTTLE TOP
To Next Page
Loading...
Need help?
General
