Instruction Booklet9-Series
◎Connect Power supply:
LED (POWER) - RED LIGHT ON
LED (CHARGE) - RED LIGHT ON
◎CC mode:
LED (CHARGE) - ORANGE LIGHT ON
◎Full charged:
LED (CHARGE)-GREEN LIGHT ON
Operating Instruction
1.Make sure the power cord, battery cable, battery terminals are in good condition.
2.Make sure the charge output voltage is the same as the connecting battery.
3.Connect the connector of battery charger to the connector of battery firstly, and then
connect the AC power
.
4.Make sure the AC voltage is correct and plug in the power cord normally.
The LED (Power) light will turn on when electric current passes.
5.During charging, LED (Charge) will indicate orange light. When it turns to green light,
that means fully charged.
LED Indication
Batteries must be charged before using the scooter for the first time and should be
recharged after each day use. You will need the scooter and the battery charger.
Maintenance & Repair must only be carried out by a Competent Engineer
or Authorised Dealer or Agent.
11
CHARGING THE BATTERIES
Figure 17
Each country may supply different charger. The charging procedure
may be different from below. If you require more details, please contact
your authorized dealer.
Be sure the scooter key is in the OFF
position
To Next Page
Loading...
Need help?
General
