c SwiftreaderX - Wiring Requirements; Network Requirements; Swift R Eader X Firewall Configuration

support@swiftlane.com | 505-657-9438
5
Wiring Requirements
Network Requirements
S. no.
S-001
CU board Power
83319E
18-22
Recommended
S-002
Lock Power
83319E
18-22
Recommended
S-003
ACM4/PD4UL/PD8UL
83319E
18-22
Recommended
S-004
Door position sensor
9829
24
Yes
S-005
Request to Exit
9829
24
Yes
S-006a
Weigand Card Reader
5504FE
18
Yes
S-006b
Weigand Card Reader
4504FE
22
Yes
S-007
Firelarm input
9829
24
Yes
S-008
RJ-45 Ethernet Cable
n/a
Cat5/5e
Yes
Signal Belden Wire part no. AWG (max - min) Shielded? Remarks
Can use multi pair
conductors to reduce
individual wires
API Endpoints
Swiftlane Door Controller Panel Firewall Configuration
Enable bidirectional connections f or port 80 and 443
Enable bidirectional (f or communication between AP I and door
controller hardware )
m q tt. g oo g leapis.com : 8883
Enable bidirectional (f or communication between AP I and door
controller hardware )
clou d iot. g oo g leapis.com : 443
Customers should allow complete outbound connections f rom Access Point devices on port 80 and
443 . T his ensures the highest level o f reliabilit y f or the s y stem .
H owever , here are some speci f ic endpoints called f rom the Swi f tlane s y stem . Please note that this is a
changing set o f requirements and ma y a ff ect f uture per f ormance o f the device . We highl y recommend
that y ou allow all outgoing 80/443 tra ff ic f rom the Swi f tlane devices .
admin . swi f tlane . com/ *
[ swi f tpass . ue . r . appspot . com/ ](< https : //swi f tpass . ue . r . appspot . com/ >)*