28
The electronic management of the product automatically identifies the available power source. When the device is
connected to the mains electricity supply, it uses this source even if internal batteries are charged, to prevent
consuming them.
3.1 Operation with power supply
It is important for the safety of the device and the user, to only use the original power supply that Manufacturer supply
as optional accesssory. Even the use of power supplies with equal plate data but not of an original type as shown here,
is prohibited, because it does not represent an index of equal safety and operational functioning.
Original power supply models:
Shenzhen HuoniuTecnology Co.,Ltd. - HNEL050100WE, Input:100÷240V~, 0.2 AMax, 50/60Hz, Output: 5V
, 1A
Shenzhen HuoniuTecnology Co.,Ltd. - HNBI050100WE, Input:100÷240V~, 0.2 AMax, 50/60Hz, Output: 5V
, 1A
Shanghai Sucheng Electronic Co.,Ltd. – SC06W-0501000V, Input:100÷240V~, 0.15 AMax, 50/60Hz, Output:
5V , 1A
A) The DC connector is located on the bottom of the
device. Release the green protective cover as shown in the
figure and insert the power supply jack.
B) Connect the power supply to the socket after having
ascertained that the type of plug is appropriate. The
original power supply provided is of universal voltage type
and is, therefore, appropriate for use regardless of the low
mains voltage available.
To avoid potentially hazardous conditions, overheating, accidental drops and/or damages, we
recommend disconnecting the power supply from the socket immediately after having finished using
the device. Do not leave the power supply connected to the socket for a long time.
Do not remove and always close the protective cap (green) of the connector on the bottom when not
using the power supply. Always carefully disconnect the power supply from the device to prevent
breakage that could affect operation. Any damages resulting from liquid penetration or mechanical
failure of the connector are not covered under the Warranty.
DO NOT FORGOT TO SWITCH OFF device at the end of its use. This device DON’T SWITCH
OFF AUTOMATICALLY when medicine when medicine is finshed to be nebulised. Only after 20
minutes of continuos operating the device is ALWAYS switch off automatically.
3.2 Operation with internal batteries
The internal lithium battery of this device, rechargeable and not replaceable by the user, allows it to works even when
the mains is not available. In full efficiency and 100% charged, the internal battery ensures up to a maximum of 220
minutes of continuous operating of device. With a full charge cycle, the battery is able to power the device to perform
up to 28 complete nebulization therapies (1 therapy = 1 total nebulization of 2.5ml of physiological NaCl 0.9%)
The battery is guaranteed for 300 full charge cycles (therefore the useful life of the battery, used and charged in the
best conditions, is at least of 1100 hours of operating).
To Next Page
Loading...
