27
2 – PREPARING THE PRODUCT
Once the drug is inserted in the relative chamber, proceed with the following operations:
A) Connect the drug chamber to the main unit making it slide along specific tracks until a click is clearly heard,
indicating its proper positioning.
Nebulisation does not start if the drug chamber is not properly engaged. In this case, pressing the ON/OFF button,
causes the electronic control of the device to flash, for a few seconds, an BLUE button backlight, that switch off
because of missing good connection. If the chamber has been properly engaged, by pressing the ON/OFF button, the
button operation BLU light flash slow (cycle of 4 sec.) and permanently until the end of treatment and switch off of
device.
B). Connect the accessory indicated by your doctor for the specific therapy to the product. Make sure you use the
correct size mask based on the patient (L for adults and S for children), in order to ensure maximum comfort and
effectiveness of the treatment.
3 – POWER SUPPLY OF THE DEVICE
KIWI Plus is equipped with electronic power supply management that allows it to function either connected to the
rechargeable batteries inside (Original power supply) or by using USB Cable Adapter.
To Next Page
Loading...
