A-1cab Produkttechnik GmbH & Co KG
Appendix A - Operation in Peel-off Mode
Components for the Peel-off Mode
The P-version printer types are specificly developed for operation in the peel-
off mode and they are equipped with dispense plate (8) and present sensor (4)
as standard.
In the peel-off mode the labels are removed from the silicon liner immediately
after printing, and then available in a dispense position (5) ready for further
processing. The see-through present sensor consisting of transmitter (1) and
receiver (3) indicates the presence of a label, and pauses the printing process
until the label is removed. After taking the label from the dispense position the
next label will be printed.
To guarantee a maximum of reliability in the peel-off mode the printer is
additionally equipped with a pair of rollers (6, 7) to cause the dispense tension.
1
2
3
4
5 6 7 8
Appendix A - Operation in Peel-off Mode
Fig. A-1 Components for Peel-off Mode
Additionally, the present sensor unit (4) is equipped with an interface (2) to
allow connection of an external control for dispense on peel-off mode.
To Next Page
Loading...
