CAB A3 - Appendix D - Maintenance; Cleaning; Cleaning the Print Roller

D-1cab Produkttechnik GmbH & Co KG
Appendix D - Maintenance / Cleaning
The A series printers require very little maintenance.
Most important, clean the printhead on a regular basis. This will ensure a high
quality printed image. It also reduces the amount of wear of the printhead.
Aside from that, the only other servicing required is to clean the outside of the
printer occasionally.
WARNING !
Before starting any maintenance, power OFF the printer and disconnect
the printer from the outlet!
General Cleaning
During the normal operation of the printer, particles of dust and paper can
accumulate inside the printer. Remove these particles with a soft brush or a
vacuum.
The cover of the printer can be cleaned with a standard cleanser.
CAUTION !
Do not use abrasive cleaners or solvents !
Cleaning the Print Roller
Accumulations of dirt on the print roller can lead to impaired media transport.
Clean the roller as follows :
1. Open the printhead.
2. Remove the media from the printer.
3. Remove all deposits with a rubber cleaner or isopropyl alcohol and a soft
cloth.
Appendix D - Maintenance / Cleaning