CAB M4 Series - Machine Parameters

68 cab Produkttechnik GmbH & Co KG
M4
Parameter Meaning
Printhead pos. Shift the print image on the label
X left to right.
Default : 0.0 mm
Printhead pos. Shift the print image on the label
Y top to bottom.
Default : 0.0 mm
Tear-off pos. Shift the tear-off position
Default : 0.0 mm
Demand sensor (only for P-version printers)
Peel position Shift the position of the dispensed
label relative to the dispense plate
Default : 0.0 mm
Backfeed Delay time between removing the
delay label from the peel position and the
backfeed of the label
Default : 250 ms
Limit peel-off Limitation of the print speed in the
spd. peel-off mode to 100 mm/s
Default : On
Cutter
(Only displayed if the cutter is attached)
Time Powersave Amount of time before switching to
powersave mode
Default : 5 min
Debug mode Activates the debug mode
Default : Off
Machine Parameters
Table 8c Overview of the "Machine parameters" Folder
Setup
Machine parameters
Selection
9,9
...
0,0
+9,9
...
-9,9
+9,9
...
-9,9
+9,9
...
-9,9
500 ms
...
0 ms
in 50 ms
increments
On
Off
60 min
...
0 min
On
Off
8. Printer Configuration