CAB M4 Series - Page 69

69cab Produkttechnik GmbH & Co KG
M4
Printhead position X
Using this setting will shift the entire print image to the left on the label. This
parameter should only be altered if you are printing the same format on several
printers, and the printed image is not consistent on each printer.
NOTICE !
The value of Printhead position X cannot be greater than the difference of
the printhead width and the defined label width in software. A value
greater than the difference will be ignored and the actual difference will
be used in place. For example, if the printhead width is 104mm and the
label width defined in software is 100mm, the printer will only accept a
value of 4mm or less for printhead position X. If Printhead position X is
set for 6mm, the printer will only shift the label 4mm.
It is possible to adjust the value for individual jobs using software. The Printer
Configuration values and software command values will be totaled together for
printing.
Printhead position Y
Using this setting will shift the entire print image up or down the label. This
parameter should only be altered if you are printing the same format on several
printers, and the printed image is not consistent on each printer.
NOTICE !
Changing the Printhead position value Y also effects the peel position
and cut position as well. It will be necessary to readjust the values for the
peel and cut positions using the previous value +/- the printhead position
value.
It is possible to adjust the value for individual jobs using software. The Printer
Configuration values and software command values will be totaled together for
printing.
Tear-off position
When the "Tear-off mode" (see chapter "Print parameters") is active, an
additional feed forward will take place after completion of the print job. This
additional feed makes it possible to tear off the last label at the tear-off plate.
Using the setting "Tear-off position" the length of the additional feed can be
adjusted.
8. Printer Configuration