CAB M4 Series - Page 70

70 cab Produkttechnik GmbH & Co KG
M4
Demand sensor - Peel position
This parameter allows for adjustment of the presentation position of the
printed label on the dispense plate.
Peel position with the initial offset value of 0 causes the printed label to be
peeled off from the liner leaving approximately a .1 (2mm) wide strip of the
label still adhering to the liner. The amount of label left adhering to the liner
can be altered with this parameter, using an offset in the range from -9.9mm to
+9.9mm. Positive offset values cause more of the label surface to protrude
past the dispense plate.
The offset values from Peel position and from software are added together for
execution. The software value does not replace the Peel position value, but
temporarily adjusts it for the current job.
Demand sensor - Backfeed delay
The "Backfeed delay" adjustment allows you to input an amount of time in
milliseconds between when the label is removed from the peel edge and when
the backfeed is executed. Using "Backfeed delay" should prevent labels from
becoming jammed between the printhead and print roller when the liner is fed
back too quickly.
Demand sensor - Limit peel-off spd.
This parameter allows to limit the print speed in peel-off mode to 4 ips
(100mm/s).
When an M4/200P printer is delivered, the maximum print speed in peel-off
mode is limited to 4 ips (100mm/s). Even if the print speed for the peel-off
mode is set higher in the software, the print job will be carried out with a speed
of 4 ips (100mm/s). This limitation guarantees correct operation of the
M4/200P in peel-off mode when using maximum supply rolls (diameter 8 in
(203mm), width 4.7 in (120mm)).
When using smaller supply rolls it is possible to operate with higher speed. For
that purpose the speed limitation must be switched off. Then the print speed
can be set on all speeds up to 6 ips (150mm/s) for M4/200P.
CAUTION !
When operating the M4/200P in peel-off mode with higher speed it is
strongly recommended to carry out some tests beforehand by using
appropriate rolls with maximum diameter !
The speed limitation in the peel-off mode does not affect any other operation
modes like tear-off mode, cut mode or external rewinding.
8. Printer Configuration