Press the reset button and hold for about 5 seconds until the green light ashes 10
times with 10 beeps. It means the memory of all recorded ngerprints has been cleared.
CLEARING THE MEMORY
To lock the safe, close the door and turn the handle to the lock position.
NOTE: Because the locking mechanism is deactivated for approximately 3 to 6 seconds
after the ngerprint is entered, wait a minimum of 6 seconds from the time your
ngerprint has been accepted to lock the safe.
WARNING: Do not leave safe unattended while open, and keep children away from safe.
LOCKING THE SAFE
Your safe comes with the beep sound turned on.
To turn the sound off, press the scanner with a recorded ngerprint for 10 seconds until
the green light ashes twice.
To turn the sound on, press the scanner with a recorded ngerprint until you hear 2
beeps and the green light ashes twice.
TURNING THE SOUND OFF/ON
4
To Next Page
Loading...