1. 11” x 9½” Large Hard-plastic Base
2. (2) Support Legs with (4) connecting Allen wrench hex bolts and washers
3. Tenderizer/Cuber Housing Assembly
WARNING! SHARP BLADES! Use caution when handling the housing assembly
DO NOT place fingers or hand into the top and bottom opening s of the housing assembly
in order to prevent injury. (It is recommended to wear steel mesh gloves when handling
housing with exposed blades)
4. Plastic Feed Chute with (2) top assembly Allen wrench hex bolts
5. (2) Blade Cleaning Combs (NOTE: An assembly thumbscrew is already be attached
to each comb with a c-clamp. Do not remove the thumbscrew from the comb)
6. Crank Handle Assembly with (1) threaded locking bolt
7. Meat Tongs
8. Large Allen Wrench for assembling legs to base and housing assembly and feed
chute to housing top
9. Small Allen Wrench for tightening blade shaft gear assembly
10. Table Mount C-clamps (2) to firmly hold unit in place during use
CAUTION: It is recommended to wear steel mesh or Kevlar®
cut-resistant gloves when handling the blade assembly
WARNING: CAREFULLY REMOVE HOUSING FROM THE STYROFOAM PACKING. CAUTION!
TENDERIZER/CUBER CUTTING BLADES ARE EXTERTREMELY SHARP! Handle the housing
assembly with care and DO NOT place hands or fingers into the housing openings in order to
prevent injury.
To Next Page
Loading...
