Cabletech URZ0336 - TROUBLESHOOTING

Owner’s manual
25
EN
TROUBLESHOOTING
Problem Possible reason Possible solution
LED indicator is not on Power adapter is
disconnected
Check the connection of
power adapter
No signal Antenna is disconnected Check antenna connection
Antenna is damaged/
improperly set
No signal is transmitted
No image or sound Improper mode has been
selected on the TV
Choose proper mode on
the TV
Information that the channel
is coded / unavailable
Coded / unavailable channel Choose another channel
Remote control does not
work
Thedeviceisturnedo󰀨 Turn on the device
The remote control is not
pointed at the device
Point the remote control at
the device no more than
8 meters from the remote
control sensor and within 30°
horizontally and 30° vertically
of the front of the unit
There are obstacles
between the remote control
and the device
Make sure there are no
obstacles between the remote
control and the device
The batteries are discharged Replace the batteries with
the new ones
Forgotten channel password
-
Delete locked channel and
scan channels again
When the device is moved
to another room, there is no
signal
Antenna connection in
newplacemaybedi󰀨erent
(lower signal strength
resulting in weaker channel
reception or no signal)
Check antenna connection
orconnectampliertothe
antenna
OADison-searchingfor
software
-
Disconnect the antenna, wait
untilsearchingisnished,
entermenu,goto[System],
[Softwareupdate]andturn
o󰀨OAD