Your vehicle’s engine should be turned
off
while
programming the transmitter. Follow these steps to
program up to three channels:
1.
If
you have not previously programmed a universal
trdsmitter channel, proceed to Step
2.
Otherwise,
hold down the two outside buttons on the universal
transmitter until the red light begins to flash rapidly
(approximately
20
seconds). Then release the
buttons. This procedure initializes the memory
and
erases any previous settings for all three channels.
2.
Hold the end
of
the hand-held transmitter against the
bottom surface
of
the universal transmitter
so
that
you
can
still see the red light.
3.
Decide which one
of
the three channels you want to
program. Using both hands, press the hand-held
transmitter button and the desired button on the
universal transmitter. Continue to hold both buttons
through Step
4.
4.
Hold down both buttons until
you
see the red light
on the universal transmitter flash rapidly and then
stop. The rapid flashing, which could take up to
90
seconds, indicates that the universal transmitter
has been programmed. Release
both
buttons once
the light starts to flash rapidly.
If
you have trouble programming the universal
transmitter, make sure that you have followed the
directions exactly as described and that the battery in the
hand-held transmitter is not dead.
If
you
still cannot
program it, rotate the hand-held transmitter end over end
and
try
again. The universal transmitter may not work
with older garage door openers that do not
meet
current
Federal Consumer Safety Standards.
If
you cannot
program the transmitter after repeated attempts, consult
your Cadillac dealer.
Be sure to keep the original hand-held transmitter
in case you need
to
erase and reprogram
the
universal transmitter.
I
-
.I
-3
2-58
-
To Next Page
Loading...
Need help?
General
