Care
of
Safety Belts
Keep belts clean and dry.
I
A
CAUTION:
Do
not bleach
or
dye safety belts.
If
you do, it
may severely weaken them. In
a
crash they might
not be able
to provide adequate protection.
Clean safety belts only with mild soap and
lukewarm water.
Glass
Glass should be cleaned
often.
GM
Glass Cleaner
(GM
Part
No.
1050427)
or a liquid household glass cleaner
will remove normal tobacco smoke and dust films.
Don’t use abrasive cleaners on glass, because they may
cause scratches. Avoid placing decals on the inside rear
window, since they may have to be scraped
off
later.
If
abrasive cleaners are used on the inside
of
the rear
window,
an
electric defogger element may be damaged.
Any
temporary license should not be attached across the
defogger grid.
Cleaning
the Outside
of
the
Windshield and Wiper
Blades
If
the windshield is not clear after using the windshield
washer, or if the wiper blade chatters when running, wax
or other material may be
on
the blade or windshield.
Clean the outside of
the
windshield with
GM
Windshield Cleaner, Bon-Ami Powder@
(GM
Part
No.
105001
1).
The windshield is clean
if
beads do not
form when
you
rinse it with water.
Clean the blade by wiping vigorously with a cloth
soaked in full-strength windshield washer solvent. Then
rinse the blade with water.
Wiper blades should be checked on a regular basis and
replaced
when
worn.
Weatherstrips
Silicone grease on weatherstrips will make them
last
longer, seal better, and not stick
or
squeak. Apply silicone
grease with a clean cloth at least every
six
months.
During very cold, damp weather more frequent
application may
be
required. (See “Recommended
Fluids and Lubricants”
in
the Maintenance Schedule
booklet.)
c
-4
6-48
To Next Page
Loading...
Need help?
General
