pll
c
Note
to
Canadian
Owners:
During programming, the
hand-held transmitter may stop transmitting after one or
two seconds.
If
you
are programming from one of these
transmitters,
you
should press and re-press the button on
the hand-held transmitter every two seconds without
ever releasing the button on the universal transmitter.
Release both buttons when the red light on the universal
transmitter begins to flash rapidly.
Operating the Transmitter
Press and hold the appropriate button on the universal
transmitter. The red light comes on while the signal
is
being transmitted.
Note that the effective transmission range of the
universal transmitter may differ from the hand-held
transmitter and from one channel to another. Also
note that the universal transmitter is disabled when the
VALET button inside
of
the glove box is activated.
For more information, see “Security Override” earlier
in this section.
Erasing Channels
To
erase all three programmed channels, hold down the
two outside buttons until the red light begins to flash.
Individual channels cannot be erased, but
can
be
reprogrammed using the procedure for programming
the
transmitter explained earlier.
Accessories
Accessories for the universal transmitter are available
from the manufacturer of the unit.
If
you
would like
additional information please call
1-800-355-35 15.
2-59
To Next Page
Loading...
Need help?
General
