c
c-
rc
Ir
.-
c
DISPLAY
ONIOFF:
Pressing this button will turn
off
the DIC, Electronic Climate Control, fuel data center,
the fuel gage, trip odometer and odometer. While the
displays
are
off, pressing the INFORMATION button
will only turn on the DIC. If the TRIP SET button
is pressed or the fuel level falls below four gallons
(15.2
L), all the displays will come back on.
ENG/MET
(EnglishMetric):
You can change the
display from English (miles) to metric (kilometers) by
pressing this button. The same button also changes other
readings (like temperature, fuel and odometer).
TRIP
SET
By using this button you can tell how
far
you’ve gone since you last set the TRIP SET back to
zero.
To
reset,
press and hold the button until zeros
appear. If your vehicle
is
domestic, the trip odometer
will return to zero after 999.9 miles
(1
609
km).
If your
vehicle
is
Canadian, the trip odometer will return
to
zero
after
1
999.9
km
(1,242
miles).
INFORMATION:
Pressing this button repeatedly will
display the AVG
MPG,
FUEL USED, AVG
MPH,
OIL
LIFE LEFT, ENGINE RPM, BATTERY VOLTS and
COOLANT
TEMP.
TIMER:
This feature
is
like a stopwatch, in that you
can clock the time it takes to get from one point
to another.
To
operate, press the TIMER button until TIMER
0O:OO:OO
is displayed on the DIC. Each of the fields for
the hours, minutes and seconds are
two
numeric digits.
Once TIMER
OFF
0O:OO:OO
is displayed, press the
TIMER button to start the timing feature. Press the
TIMER button again to stop
it,
If
you will be starting
and stopping
your
Cadillac, during a trip for instance,
the TIMER feature will automatically
start
timing where
it
left off when you last stopped. To reset it, press and
hold the RESET button until the display reads TIMER
0O:OO:OO.
Press the INFORMATION button to exit from
the TIMER function.
RESET
Pressing this button will reset the
MPG
AVG,
FUEL USED, AVG
MPH
and
OIL
LIFE
LEFT.
Pressing
RESET when a non-resettable display appears will
cause
a
“recall” mode
to
occur. When this happens, all
DIC warning messages that have been displayed since
the ignition key was turned to RUN will redisplay.
If
no
messages were displayed, a MONITORED SYSTEMS
OK
message will appear.
2-75
To Next Page
Loading...
Need help?
General
