DEFOG:
Press thl's button to divide the air between the
windshield and
the
heater outlets. This is useful when
fog appears on the windshield or side glass due to
sudden rain or snowy conditions. This feature is not
available with the heated windshield option.
AUTO/ECON:
Press this button
to
switch between
AUTO
and
ECON.
The
ECON
setting attempts to keep
air at a selected temperature, however, it does not
remove humidity from the air. Use this setting in cold
or
cool weather to save fuel. The AUTO setting is used
when it's warm outside and you need
to
cool
the
air
in
order to maintain a selected temperature and blower
speed.
FAN
SPEEDS:
Press the button with the
fan
symbol until AUTO is displayed on the screen.
At
this
setting, the fan speed
is
automatically controlled. If
it
is
cold outside, the blower may not
run
in
the maximum
high
fan
speed right away. The system checks the
temperature of the engine coolant to assure it is warm
enough to provide heat. When
the
engine
coolant
is
wm,
the controller allows the fan to gradually increase
to a higher speed. This prevents cold air from blowing
into the passenger compartment.
If
you
want the blower
fan at a high speed, press the up arrow button until you
see HI
on
the display.
If
you want the fan speed to be
automatic, but
you
like the fan speed to
be
higher than
the
AUTO
setting, press the fan symbol button until HI
AUTO
is
shown on the display.
If
you want the blower
fan at a
low
speed, press the down mow button until
LO
is
shown on the display. If you want the fan speed to
run lower than the
AUTO
setting,
press the button until
AUTO
LO
is
shown on the display.
9
DEFROST:
Press this button to quickly remove
fog or frost from the windshield.
This
setting sends most
of the airflow to the windshield with only a small
amount to the floor outlets.