k
4.
With the coolant surge
tank
pressure cap
off,
start
the
engine and let it run until
you
can
feel the upper
radiator hose getting hot. Watch out for the engine
fans.
By
this time, the coolant level inside the coolant
surge tank may be lower.
If
the level is lower, add
more
of
the proper mix to the coolant surge tank
until the level reaches about
2.5
inches
(60
mm)
below the base
of
the filler neck.
5.
Then replace the pressure cap. Be sure the
arrows
on
the pressure cap line
up
like this.
Start
the
engine and allow
it
to
warm
up.
If
the
CHECK
COOLANT LEVEL
message does not appear on the
Driver Information Center, coolant is at the proper fill
level.
If
a
CHECK
COOLANT
LEVEL
message does
appear, repeat Steps 1 to
3
or see your dealer.
To Next Page
Loading...
