t
19
Using Foam-Type Cleaner
on
Fabric
0
a
0
a
a
a
0
0
a
0
0
Vacuum and brush the area to remove any loose dirt.
Always clean a whole
trim
panel
or
section. Mask
surrounding trim along stitch
or
welt lines.
Mix Multi-Purpose Powdered Cleaner following the
directions on the container label.
Use suds only and apply with
a
clean sponge.
Don’t saturate the material.
Don’t rub it roughly.
As
soon
as
you’ve cleaned the section, use
a
sponge
to remove the suds.
Rinse the section with a clean, wet sponge.
Wipe
off
what’s left with a slightly damp paper towel
or cloth.
Then dry it immediately with a blow dryer.
Wipe with
a
clean cloth.
Using
Solvent-Type Cleaner on Fabric
First, see if you have
to
use solvent-type cleaner at
dl.
Some spots and stains will clean off better with just
water and mild soap.
If you need to use a solvent:
Gently scrape excess soil from the trim material
with
a
clean, dull knife or scraper. Use very little cleaner,
light pressure
and
clean cloths (preferably
cheesecloth). Cleaning should start at the outside
of
the stain, “feathering” toward the center. Keep
changing to a clean section of the cloth.
0
When you clean a stain from fabric, immediately
dry
the area with a blow dryer
to
help prevent a
cleaning ring.
c
6-45
To Next Page
Loading...
Need help?
General
