This feature is mounted
on
the passenger’s interior side
of the windshield behind the rearview mirror and is used
to automatically operate the wipers by monitoring the
amount
of
moisture that
is
on
the windshield.
The Rainsense system can be activated by turning the
wiper stalk
to
one
of
the five sensitivity levels within the
AUTO
DELAY area.
Turn
the stalk toward you for
minimum sensitivity and away from you for maximum
sensitivity.
A
single wipe will occur each time
you
turn
the wiper stalk to a higher sensitivity level.
An
initial
wipe occurs when
you
turn
the ignition
on
as
a
reminder
that Rainsense is active. The windshield wipers
also
remain in a “high park” position, even when the ignition
is turned
OFF.
The Rainsense wipers operate in a delay mode
as
well
as,
a
continuous low or high speed depending on the
amount
of
moisture and the sensitivity level. The
MIST
and “wash” cycles operate as normal and are not
effected by the Rainsense function.
NOTICE:
I
-
--
-~
The Rainsense feature should be turned
off
when
going through a car wash
to
avoid damage.
It
is
important to note that the Rainsense wiping feature
(AUTO DELAY) can be overridden at any time
by
manually changing the wiper control to LO
or
HI
speed.
Note that if you ever
need
to
replace the windshield,
make sure it is Rainsensor compatible.
2-34
-
To Next Page
Loading...
Need help?
General
