Windshield Washer
Windshield Wipers
You control the windshield wipers by turning the band
with the wiper symbol on it.
(!$
(Mist):
For a single wiping cycle, turn the band
to
mist. Hold it there until the wipers start. Then let go. The
wipers
will
stop after one wipe.
If
you want more
wipes, hold the band on mist longer.
9
(Delay):
You
can set the wiper speed for a long or
short delay between wipes. This can be very useful
in light rain or snow. Turn the band
to
choose the delay
time. The closer
to
the top
of
the lever, the shorter
the delay.
0
(Low Speed):
For steady wiping at low speed,
turn the band away from you
to
the first solid band past
the delay settings. For high-speed wiping, turn the
band further,
to the second solid band past the delay
settings. To stop the wipers, move the band to
off.
(High Speed):
For high-speed wiping, turn
the band further,
to
the second solid band past the
delay settings.
0
(Off):
To stop the wipers, move the band to
off.
Be sure to clear ice and snow from the wiper blades
before using them. If they’re frozen
to
the windshield,
carefully loosen or thaw them.
If
your blades do become
worn or damaged, get new blades or blade inserts.
@
(Washer Fluid):
There is a paddle marked with the
windshield washer symbol at the top of the multifunction
lever. To spray washer fluid on the windshield, push
the paddle. The wipers will clear the window and then
either stop or return
to
your preset speed.
1
I
In freezing weather, don’t use your washer
until the windshield is warmed. Otherwise the
washer fluid can form ice on the windshield,
blocking your vision.
3-9
To Next Page
Loading...
