SCAN: To scan stations, touch SCAN. The radio will go
to a station, play for a few seconds, then go on to the
next station. Touch SCAN again to stop scanning.
To scan preset stations, touch and hold SCAN
for two seconds. It will only scan the audio source it is
in, with the exception of FM 1 and FM 2, which will both
be scanned if in that source. Touch SCAN again to
stop scanning.
RDS (Radio Data System): See “Radio Data System
(RDS)” later in this section for more information.
MSG (Message): See “Radio Data System (RDS)” later
in this section for more information.
AutoSet: Touch AutoSet to replace currently stored
preset stations with the strongest stations available in
the immediate area. Touch AutoSet again to return
to the original preset stations.
SOUND: See “Sound Menu” following in this section for
more information.
DSP: See “Adjusting the Speakers” later in this section
for more information.
Sound Menu
Touch SOUND at the bottom of the main audio screen,
source menu, or DSP menu to change the tone,
DSP, if equipped, fade, and balance for all sources.
3-8
To Next Page
Loading...
Need help?
General
