DVD Player
To use the player as a video DVD player, you must first
remove the navigation map DVD or music CD. While
playing a video DVD, the navigation system is not
available. The message “The disc installed is not a map
DVD” will appear on the display if any of the navigation
hard keys are pressed.
This feature will not operate unless the vehicle is in
PARK (P).
To remove the navigation map DVD and load a
video DVD, use the following steps:
1. With the vehicle in PARK (P) and the ignition ON,
press and hold the TILT hard key until a beep is
heard. The faceplate of the system will open.
2. If a map DVD or a music CD is loaded, the system
will automatically eject it. Gently remove it from the
slot and return it to its case.
3. Load the video DVD into the slot. The system will
pull the DVD into the player.
4. Press and release the TILT hard key to close the
faceplate.
Notice: Shifting out of PARK (P) with the system’s
faceplate open will cause the faceplate to close
automatically. This could cause damage to a
CD, DVD or the system if it is partially loaded.
Before shifting out of PARK (P), make sure that the
DVD or CD is loaded properly. The vehicle must
be shifted back into PARK (P) to close the faceplate.
Once the faceplate is closed and a video DVD is
loaded, the system will automatically play the DVD.
Playing a DVD
There are three ways to play a DVD depending on
which screen you are on. They are the following:
• Once a DVD is inserted, the system will
automatically play the DVD.
• If you are on a map screen, touch the DVD source
button.
• From the audio screen, press the DVD hard key.
3-24
To Next Page
Loading...
Need help?
General
