Navigation right map [change map] direction: This
command instructs the system to change the direction of
the map to heading up or north up depending on the
previous setting. This command is available while a map
screen is displayed when in dual map mode.
Navigation [show] dual map [mode], navigation
[change to] dual map [mode], navigation [show]
single map [mode], navigation [change to] single
map [mode]: These commands instruct the system to
switch between dual and single map modes. These
commands are available while a map screen is
displayed.
Navigation store [this point], navigation mark [this
point]: These commands instruct the system to store or
mark a point in its memory. These commands are
available while a map screen is displayed.
Navigation [change to] 3-D map [mode], navigation
[change to] 2-D map [mode]: These commands
instruct the system to switch between 2-D and 3-D map
modes. These commands are available while a map
screen is displayed.
Point of Interest (POI) Commands
The following is a list of POI commands. State the
commands exactly as they are written to receive
information from the system regarding that specific
command. POIs will only be displayed on the map screen
if the map scale is
1
⁄
2
mile (1 km) or less. If you try to have
POIs displayed on a map with the wrong scale, the
system will remind you of this. When you are ready to exit
the POI command mode, state “POI off”. The available
POI commands are the following:
Automobile Commands
• Navigation Automobile Club
• Navigation Triple A
• Navigation Car Wash
• Navigation Gas Station
• Navigation Gas
• Navigation Parking
• Navigation Parking Lot
• Navigation Parking Garage
• Navigation Car Park
• Navigation Auto Service and Maintenance
• Navigation Auto Service
• Navigation Other Automotive
• Navigation GM
4-8
To Next Page
Loading...
Need help?
General
