Using the OnStar
®
Screen to Make a
Phone Call
To make a phone call using the OnStar
®
screen do the
following:
1. Press the AUX hard key.
2. Touch the OnStar
®
screen button.
3. Enter the phone number using the numeric keypad.
4. Touch the place/end call screen button to place
the phone call.
5. If you need to use the tone send button for checking
voice mail or responding to an automated request,
enter the appropriate number(s) using the keypad
and then touch the tone send button. Once that set
of numbers has been sent, the tone send button
will be dimmed until another set of numbers is input
on the keypad.
6. To end the call, touch the place/end call screen
button. It will be red while you are on the call.
Configure Menu
Press the CONFIG hard key to access this menu,
allowing you to adjust several of your system’s features
and preferences.
2-49
To Next Page
Loading...
Need help?
General
