Radio [select] center point [mode], radio [select] talk
[mode], radio [select] rear seat [mode], radio
[select] driver [mode], radio [select] normal [mode]:
These commands instruct the system to switch
between the different DSP settings.
Radio autostore: This command instructs the system
to enter radio autostore mode. The autostore function
must be selected on from the audio setup screen
for each band.
Radio help: This command instructs the system to
assist with radio commands. The radio commands will
be displayed on the screen.
CD Commands
The following are CD/MP3 commands you can access
by clearly stating the commands exactly as they are
written. The commands are only available when a CD
is inserted.
CD, CD turn off: These commands instruct the system
to turn the audio system CD Changer on and off.
CD [set] balance left, CD [set] balance right:
These commands instruct the system to increase the
balance to the maximum setting left or right.
CD [set] fade front, CD [set] fade rear: These
commands instruct the system to increase the fade to
the maximum setting front or rear.
CD [set] balance center, CD [set] balance middle,
CD [set] fade center, CD [set] fade middle: These
commands instruct the system to set the fade and
balance to the center position.
CD scan up: This command instructs the system to
scan upward through tracks.
CD [select] disc (one, two, three, four, five, or six):
These commands instruct the system to select disc
number one through six. The system will select
the specified disc and start to play it.
CD [select] track (one, two, three, etc.): This
command instructs the system to select a specific
track number.
CD [select] disc (one, two, etc.) track (one, two,
etc.): This command instructs the system to select a
specific disc and track number on that disc.
CD [select] next track, CD [select] previous track:
These commands instruct the system to go to the
next or previous track on a disc.
4-15
To Next Page
Loading...
