To select a category, do the following:
1. Select the XM™ audio source.
2. Select the Category screen button.
3. The Navigation System will display the available
category on the presets.
4. Use the left and right arrows to scroll through the
presets or use the seek up/down hard key to go to
the next category.
5. Select the desired category by touching it from the
screen.
To view the available channels within the category,
select the category as explained above, and then use
the tune knob or seek button to scroll through the
available channels within the selected category.
Category Scanning: This function allows you to scan
through the channels on a specific category. To
activate the category scan function, do the following:
1. Select the XM™ audio source.
2. Select the Category screen button.
3. The Navigation System will display the available
category on the presets.
4. Use the left and right arrows to scroll through the
presets or use the seek up/down hard key to go to
the next category.
5. Select the desired category by touching it from the
screen.
6. Touch the Scan screen button and the system will
can through the channels available within the
selected category.
Scan and Preset Scan: While in XM™, the scan
function allows you to scan through the XM™ band.
Press the Scan screen button and the system will start
scanning. Press the Scan button again to turn the
scan function off. Press and hold the Scan screen button
to have the system scan the presets stored on the
XM™ band.
3-9
To Next Page
Loading...
Need help?
General
