3. Disconnect the red positive (+) cable from the
vehicle with the good battery.
4. Disconnect the red positive (+) cable from the
other vehicle.
5. Return the remote positive (+) terminal cover
to its original position.
Headlamp Aiming
The vehicle has a visual optical headlamp aiming
system. The aim has been preset at the factory
and should need no further adjustment.
However, if the vehicle is damaged in an accident,
the headlamp aim may be affected and adjustment
may be necessary.
If oncoming vehicles flash their high beams at
you, this may also mean the vertical aim needs to
be adjusted.
It is recommended that the vehicle is taken to your
dealer for service if the headlamps need to be
re-aimed. It is possible however, to re-aim the
headlamps as described in the following procedure.
Notice: To make sure your headlamps are
aimed properly, read all the instructions before
beginning. Failure to follow these instructions
could cause damage to headlamp parts.
The vehicle should be properly prepared as follows:
• The vehicle should be placed so the headlamps
are 25 ft. (7.6 m) from a light colored wall.
• The vehicle must have all four tires on a level
surface which is level all the way to the wall.
• The vehicle should be placed so it is
perpendicular to the wall.
• The vehicle should not have any snow, ice, or
mud on it.
• The vehicle should be fully assembled and all
other work stopped while headlamp aiming is
being performed.
• The vehicle should be normally loaded with a
full tank of fuel and one person or 160 lbs
(75 kg) sitting on the driver’s seat.
• Tires should be properly inflated.
• The spare tire is in its original location in
the vehicle.
389
To Next Page
Loading...
Need help?
General
