USB Media Recording
A USB Mass Storage device such as a “pen drive”
or a portable USB hard drive can be connected to the
USB port to record media contents, such as compressed
audio files from the USB storage device onto the HDD.
The USB port is located in the center console bin,
between the Accessory Power Outlet (APO) socket and
the auxiliary input jack.
In addition to recording the content from the USB storage
device, content can be played back directly from the
USB device.
USB Background Recording
If the content of a USB device is chosen to be copied,
these media files are copied to the hard drive.
The recording process occurs in the background and
does not affect playback from any source, including
the USB device itself. The quality of the listening
experience should be the same whether recording in the
background or not, and the speed of the recording
process does not take any longer than normal.
Timeshift cannot be activated during the background
recording function.
Using the Radio Controls to Connect and
Control Your iPod
You can control your iPod using the radio buttons and
knobs and display your iPod song information on
the radio’s display. To connect and control your iPod
using the radio controls, your vehicle must have a USB
port. If it does, it is located in the center console bin.
You will also need a special iPod connection cable
that can be purchased with your vehicle or may
be available after, from your dealer/retailer. See your
dealer/retailer for more information.
This feature supports the following iPod models:
• Fifth generation or later iPod
• First or Second generation or later iPod Nano*
* For proper operation, make sure your iPod has the
latest firmware from Apple
®
. Your iPod firmware can
be updated using the latest iTunes application.
See www.apple.com/itunes.
3-31
To Next Page
Loading...
Need help?
General
