Cadillac Escalade Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
13690472) - 2021 - CRC - 5/15/20
VEHICLE CARE 405
Removing the Spare Tire and
Tools
The equipment needed to change a
flat tire is stored in the rear of the
vehicle. The jacking tools are under
the load f loor, secured with velcro
straps. The jack is behind a door in
the trim panel on the driver side.
1. Pull to open the trim panel door.
The third row driver side seat
may need to be folded to access
the trim panel door.
2. Turn the jack knob
counterclockwise to release the
jack and wheel blocks from the
bracket. If equipped, remove the
wheel blocks from the jack and
place the wheel blocks on both
sides of the tire at the opposite
corner of the tire being changed.
See If a Tire Goes Flat 0 403 for
more information on the
placement of the wheel blocks.
Place the jack and wheel blocks
near the tire being changed.
Short Wheel Base Shown, Extended
Wheel Base Similar
3. Lift the load floor. Remove the
jacking tools and place them near
the tire being changed.
To Next Page
Loading...
