Cadillac XT4 Owner Manual (GMNA-Localizing-Europe-15440913) - 2022 -
CRC - 5/13/21
VEHICLE CARE 337
5. Slide the base of the tyre sealant
canister (3) into the slot on the top
of the compressor (6) to hold it
upright.
Make sure the tyre valve stem is
positioned close to the ground so
the hose will reach it.
6. Remove the valve stem cap from
the flat tyre by turning it
anticlockwise.
7. Attach the sealant/air hose (2) to
the tyre valve stem by turning it
clockwise until tight.
8. Plug the power plug (9) into the
accessory power outlet in the
vehicle. Unplug all items from
other accessory power outlets. See
Power Sockets 0 95.
If the vehicle has an accessory
power outlet, do not use the
cigarette lighter.
If the vehicle only has a cigarette
lighter, use the cigarette lighter.
Do not pinch the power plug cord
in the door or window.
9. Start the vehicle. The vehicle must
be running while using the air
compressor.
10. Press the on/off button (5) to turn
the tyre sealant and compressor
kit on.
The compressor will inject sealant
and air into the tyre.
The pressure gauge (8) will initially
show a high pressure while the
compressor pushes the sealant into
the tyre. Once the sealant is
completely dispersed into the tyre,
the pressure will quickly drop and
start to rise again as the tyre
inflates with air only.
11. Inflate the tyre to the
recommended inflation pressure
using the pressure gauge (8). The
recommended inflation pressure
can be found on the Tyre and
Loading Information label. See Tyre
Pressure 0 321.
The pressure gauge (8) may read
higher than the actual tyre
pressure while the compressor is
on. Turn the compressor off to get
an accurate pressure reading. The
To Next Page
Loading...
