Cadillac XT4 - Page 45

Cadillac XT4 Owner Manual (GMNA-Localizing-Europe-15440913) - 2022 -
CRC - 5/13/21
44 SEATS AND RESTRAINTS
2. Adjust all available memor y
features to the desired driving
position.
3. Press and release SET; a beep will
sound.
4. Immediately upon releasing SET,
press and hold memory button 1 or
2 matching the current Driver's
RKE transmitter number until two
beeps sound. If too much time
passes between releasing SET and
pressing 1 or 2, the two beeps will
not sound indicating memory
positions were not saved. Repeat
Steps 3 and 4 to try again.
5. Repeat Steps 1–4 for the other RKE
transmitter 1 or 2 using the other 1
or 2 memory button.
If you are the only driver, it is
recommended to save the preferred
driving position to both 1 and 2.
To save the common exit seating
position to
B that is used by all
drivers for Manually Recalling Seating
Positions and Auto Seat Exit Memory
Recall features, repeat Steps 1–4 using
B, the exit button.
Manually Recalling Seating
Positions
Press and hold 1, 2, or
B button until
the recall is complete, to recall the
positions previously saved to that
button.
Manual Memor y recall movement for
1, 2 or
B buttons may be initiated
and will complete to the saved
memory position if the vehicle is in or
out of P (Park).
Enable Automatic Recalls under
Vehicle Personalisation Settings
.
For Seat Entr y Memor y that begins
movement to the preferred driving
position of the 1 or 2 button when
the vehicle is turned on, select the
Settings menu, then Vehicle, then
Seating Position, then Seat Entr y
Memory, and then Select ON or
OFF. See “Auto Seat Entr y Memory
Recall” later in this section.
.
For Seat Exit Memory that begins
movement to the preferred exit
position of the
B button when the
vehicle is turned off and the driver
door is open or opened, select the
Settings menu, then Vehicle, then
Seating Position, then Seat Exit
Memory, and then Select ON or
OFF. See “Auto Seat Exit Memory
Recall” later in this section.
.
See Vehicle Personalisation 0 121 for
additional setting information.
Auto Seat Entry Memory Recall
Seat Entry Memor y will automatically
begin movement to the seating
positions of the 1 or 2 button
corresponding to the driver's RKE
Transmitter number 1 or 2 detected
by the vehicle when:
.
The vehicle is turned ON.
.
Seating positions have been
previously saved to the same 1 or 2
button. See “Saving Seating
Positions” previously in this section.
.
Seat Entry Memor y is enabled. See
“Enable Automatic Recalls” under
“Vehicle Personalisation Settings”
previously in this section.
.
The gear lever is in P (Park).
Seat Entry Memor y Recall will
continue if the vehicle is changed out
of P (Park) prior to reaching the saved
memory position.