CADO Leaf Portable MP-C30 - Lamp on;off control; Adjusting lamp brightness levels; Memory function behavior

11
EN
Lamp controls
• If the air purier function is stopped, the lamp will turn OFF as well if it is in use.
• If the lamp is turned OFF while the air purier function is being used, the lamp will remain
OFF when the air purier function is turned ON again. Pressing the lamp control button
again will turn the lamp ON.
Lightly pressing the lamp control button will switch between ON and OFF. The lamp can be used
even when the air purier function is not being used.
Changing the lamp brightness
Holding the lamp control button for a second or longer will change the lamp brightness.
(High) (Middle) (Low)
If the brightness is changed, the last brightness setting will be retained even if the lamp is
turned OFF.
Memory function
If USB power from the base unit is disconnected during operation, all operation will stop and the
lamp will turn OFF as well. When this happens, the mode prior to the power being disconnected,
the lamp ON/OFF state, and the lamp brightness will be retained.
If USB power is reconnected, operation will resume using the last saved state, and the lamp will
turn ON as well.