25
3
Fig. 17
Fig. 18
Fig. 15
Fig. 16
Fig. 19
2
1
2
1
2
1
2
•Lift the lever (1) and fit the capsule container (2) in its housing
in the machine (Fig. 15)
When inserted correctly, rest your thumb on the lever (1)
and the other fingers under the capsule container (2) and
press firmly on both while closing your hand as shown
(Fig. 16)
• Place a cup under the outlet and press the switch (3) to start
the flow; when you have obtained the desired quantity, press
the switch (3) again to stop the flow. (Fig.17)
Programming delivery
Press and hold the dispensing switch (3) for at least 10 seconds,
and release the switch when the desired quantity is reached. In
this way, your machine will memorize the exact amount for
succeeding deliveries.(Fig. 17)
NOTE
Do not press the dispensing switch with the tank empty. If the
tank should empty during use, stop the flow immediately and
fill the tank.
SUGGESTION: when preparing drinks, use thick preheated
cups to prevent the coffee/tea from cooling too quickly
(to preheat the cup just run a little hot water in them from
your kitchen tap).
After making coffee or tea
After making coffee or tea, lift the lever to remove the
capsule container and wait a few second for the
pressure to stabilize, then:
•Remove the capsule container (2) (Fig. 18)
•Remove the lid from the capsule container and remove
the capsule (Fig. 19)
• If the capsule is COMPOSTABLE Vergnano, you can dispose
of it in FOOD WASTE.
•After expelling the capsule, clean the capsule container (2)
thoroughly by rinsing it under the tap so as to eliminate any
residues left.
IMPORTANT: for correct hygiene we recommend
removing the used capsule immediately.
To Next Page