EasyManua.ls Logo

CAIRE NewLife Elite User Manual

CAIRE NewLife Elite
49 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
MN240-1 Rev C
1
NewLife Family Technical Manual MN240-1
Question and Answer IconNeed help?

Do you have a question about the CAIRE NewLife Elite and is the answer not in the manual?

CAIRE NewLife Elite Specifications

General IconGeneral
Oxygen OutputUp to 5 LPM
Operating Frequency60 Hz
TypeOxygen Concentrator
Oxygen Flow0.5 - 5 LPM
Oxygen Concentration87% to 96%
Operating Voltage120 V AC
Noise Level45 dBA
Operating Temperature41°F to 104°F (5°C to 40°C)
Operating HumidityUp to 95% non-condensing
Alarmspower failure

Summary

Section 1.0 Introduction

1.1 Important Notice and Symbol Explanations

Explains warning, caution, and note symbols used in the manual for safety and information.

1.2 Equipment Provider Responsibility

Outlines the duties of equipment providers for handling, operation checks, patient instruction, and concentration checks.

Section 2.0 Operation Check and Oxygen Concentration Test

2.2 Operation Check

Details the required checks after manufacturing and before delivery to ensure proper unit function.

2.3 Safety and Alarm Features and Alarm Test Procedures

Describes the audible and visual alarm system for power failure, general malfunction, and low oxygen.

Section 3.0 User Instructions

3.2 Routine Maintenance by the User

Outlines simple routine maintenance tasks for users to ensure accurate output and efficient operation.

Section 4.0 Provider Instructions

Section 6.0 Troubleshooting

6.1 Operating Pressure Test

Describes a diagnostic procedure to test operating pressure for servicing when concentration is low.

6.2 General Troubleshooting

Offers initial steps to isolate malfunctions before using the troubleshooting chart.

6.3 Troubleshooting Chart

A table listing problems, probable causes, and solutions for common unit malfunctions.

Section 5.0 Main Components

5.9 Product Regulator Check and Setting

Outlines procedures for checking and setting the product regulator for normal operation.

Related product manuals