CAIRE Eclipse 5 - User Manual

Other manuals for CAIRE Eclipse 5

Provider Technical Maunal84 pages

Quick Start Guide4 pages

Questions and Answers

R
Robert SimpsonAug 19, 2025
What to do if the red light is solid and there is a constant beep on my CAIRE Personal Care Product Eclipse 5?
- M
  Michael HillAug 20, 2025
  If the red light is solid, there's a constant beep, and your Eclipse 5 isn't delivering oxygen or powering on, it likely needs a reset after a temporary power loss. Here’s what you should do: 1. Remove the power cartridge and disconnect the AC or DC power supply. The red light should disappear. Wait about 20 seconds, then reconnect the power sources and try powering on the Eclipse 5 again. 2. Check the external power supply connections to ensure they are secure at the Eclipse 5, the transformer, and the outlet. 3. Try a different electrical outlet. 4. Check that the status LED on the external power supply and the external power LED on the Eclipse 5 are lit. If not, try another external power supply.
L
lori24Aug 22, 2025
What to do if the red light is flashing on my CAIRE Personal Care Product Eclipse 5?
- E
  Edward AllenAug 22, 2025
  If the red light is flashing and the alarm is beeping 3 times every 2 minutes on your CAIRE Eclipse 5, it indicates low oxygen levels. Here’s how to address it: * Ensure the air intake filter isn't clogged. Clean or replace it if needed. * Make sure the Eclipse 5 is in a well-ventilated area, with at least 3 inches of space behind it. * If in a car, position the Eclipse 5 with the back facing outward. * Check and replace the internal filters (HEPA, Compressor Intake) if they are dirty.
S
sbookerAug 23, 2025
What to do if the yellow light is flashing and the alarm is giving 2 beeps every 30 seconds on CAIRE Personal Care Product Eclipse 5?
- D
  dsullivanAug 25, 2025
  If the yellow light is flashing and the alarm is beeping twice every 30 seconds on your CAIRE Eclipse 5, it means the power cartridge voltage is low. To fix this, plug the Eclipse 5 into an AC or DC power supply to recharge the power cartridge, or replace it with a fully charged one.
W
washingtonjohnAug 26, 2025
Why is my CAIRE Personal Care Product Eclipse 5 power cartridge draining while plugged in?
- R
  Robert FrazierAug 26, 2025
  If your CAIRE Eclipse 5 power cartridge is draining while plugged in, the device isn't receiving power from the supply. Here’s how to troubleshoot: 1. Ensure the outlet is providing power and is not a dimmer circuit or power strip. 2. Check that all cable connections are secure at the wall/vehicle and concentrator, including the transformer if using an AC power supply. 3. Make sure the green power verification lights are on, both on the power supply transformer and on the Eclipse 5 control panel. 4. If the lights are off, disconnect and reconnect all power supply connections after 20 seconds.
J
Jeffrey BridgesAug 28, 2025
What to do if the yellow light is flashing on my CAIRE Personal Care Product Eclipse 5 and there is no audible alarm?
- G
  gerald83Aug 28, 2025
  If the yellow light is flashing on your CAIRE Eclipse 5 and there's no alarm, it indicates low oxygen levels. Here’s what you can do: 1. Check the air intake filter and clean or replace it if it's clogged. 2. Ensure the Eclipse 5 is in a well-ventilated area with at least 3 inches of clearance behind it. 3. If using in a car, make sure the back of the unit faces outward. 4. Perform preventative maintenance and replace the HEPA, Air Inlet, and Compressor Intake filters.
R
Robert SnowAug 29, 2025
What to do if the yellow light is flashing and the alarm is giving 1 beep every 2 minutes on my CAIRE Personal Care Product Eclipse 5?
- P
  Paula CalhounAug 29, 2025
  If the yellow light is flashing and the alarm is beeping once every 2 minutes on your CAIRE Eclipse 5, it means there's a flow restriction causing low or blocked flow. Try these steps: 1. Clean and replace the cabinet inlet filter. 2. Check the cannula for kinks or blockages. If using a humidifier, ensure it's properly filled and not causing a blockage. 3. Ensure the Eclipse 5 has proper ventilation, with at least 3 inches of space around the vents. 4. Remove any external tubing to check if attached devices are causing a flow restriction. 5. If recently serviced, check for kinked tubing between the circuit board and oxygen outlet.
J
Jasmine EllisSep 1, 2025
Why does my CAIRE Personal Care Product Eclipse 5 beep 3 times when powered on?
- M
  Mrs. Savannah KlineSep 1, 2025
  The CAIRE Eclipse 5 beeps three times upon startup because the internal battery that powers the alarms is low and needs replacement. Consider performing preventative maintenance.
J
jason09Sep 3, 2025
What does it mean if my CAIRE Personal Care Product Eclipse 5 display screen says “FAIL”?
- H
  Holly BairdSep 3, 2025
  If your CAIRE Eclipse 5 displays “FAIL” and isn't delivering oxygen or powering on, it indicates a system malfunction. Here's what to do: 1. Remove the power cartridge and disconnect the AC or DC power supply. The red light and FAIL message should disappear. Wait about 20 seconds, then reconnect the power sources and try to power it on again. 2. If it powers on, monitor for the FAIL message reappearing.
T
Thomas FinleySep 4, 2025
How to fix CAIRE Personal Care Product Eclipse 5 power cartridge not lasting long?
- K
  Keith ParkerSep 4, 2025
  If the power cartridge of your CAIRE Eclipse 5 isn't lasting as long as it should, it might not have been fully charged. Connect it to AC or DC power and ensure it charges for 2-5 hours until the battery icon is full and not flashing before use.
W
William WalkerSep 7, 2025
How to fix CAIRE Personal Care Product Eclipse 5 power cartridge not charging?
- A
  Alexander MurraySep 7, 2025
  If the power cartridge on your CAIRE Eclipse 5 isn't charging, it's likely not receiving external AC or DC power. Here’s how to troubleshoot: 1. Verify the outlet is providing power and is not connected to a dimmer circuit or power strip (if using AC). 2. Check that all cable connections are secure at the wall/vehicle and concentrator, including the transformer if using AC power. 3. Ensure the green power verification lights are on, both on the power supply transformer and on the Eclipse 5 control panel. 4. If the lights are off, disconnect and reconnect all power supply connections after 20 seconds.