To Fill the Top Fill Stroller/Sprint
1. Clean the fill connectors on both the stationary and the
Stroller/Spirit with a clean, dry, lint-free cloth.
Caution: The fill connectors must be dry, because
moisture can cause your Stroller/Sprint and stationary
unit to freeze together.
2. Make sure the flow control knobs on
both the Stroller/Sprint and
reservoir are in the off (0) position.
3. Position the fill connector in the
upright position over the stationary
unit’s connector.
4. a. If your connector is a push-on:
Lower the Stroller/Sprint unit on to the stationary
until you feel the connector engage.
7
b. If your connector is Cryo2:
Rotate Stroller/Sprint until you feel the connectors
engage. Then, carefully and firmly, rotate the
Stroller/Sprint counterclockwise ( ) while pressing
downward.
c. If the connector is a Penox, Life-Ox, or Lincare:
Rotate Stroller/Sprint until you feel the connector
engage. Then, carefully and firmly, rotate the
Stroller/Sprint clockwise ( ) while pressing downward.
Note: Continued on step 6 (page 9).
Step 3
Step 4a Step 4b Step 4c
Stroller/Sprint
To Next Page
Loading...
