Stroller/Sprint
8
To Fill the Side Fill Stroller/Sprint
1. Clean the fill connectors on both the stationary and
the Stroller/Sprint with a clean, dry, lint-free cloth.
Caution: The fill connectors must be dry, because
moisture can cause your Stroller/Sprint and stationary
unit to freeze together.
2. Make sure the flow control knobs on both the
Stroller/Sprint and reservoir are in the off (0) position
3. Make the Stroller/Sprint fill connector is in the upright
position to the stationary connector.
4. Rotate the Stroller/Sprint counterclockwise ( ) until
you feel the pin and slot engage.
5. Carefully and firmly rotate the Stroller/Sprint back to
the upright position. Now the units are locked
together.
Note: Continued on step 6.
Step 3
Step 4 Step 5
To Next Page
Loading...
