9
Opening the Front Panel For Electrical AccessOpening the Front Panel For Electrical Access
Caution: Pinch Points.
When snapping panels back into place your
spa, be cautious of your hand position. Avoid
placing your ngers or hands over the edges
of corners or panels, it may result in injury
once panels lock into place.
Cal Spas are designed with innovative snap in panels and corners. In order to access the control box
for electrical hook up, plumbing, or pumps inside of your spa, you will need to remove the corner
panels and the front panel. The following tutorial is designed to illustrate the process of removing/re-
installing any corner panel, and any side panel.
Before starting, make sure you wear gloves
when removing any panel from your spa.
PINCH POINTS.
Keep ngers, hair and
loose garments clear
from edges of spa
panels.
In order to remove the front panel, the front
corners of the spa must be removed prior to
removing the front panel.
Start by clasping the corner panels outer lip.
Depending on your height and strength, you
may position your hands lower.
Step 1
Once the corner is removed, place aside with
great care of not bending or stepping on the
protruding clamps behind the corner.
Repeat the removal process with the corner
panel of the other end of the front of the spa.
Step 2
Begin by removing support screws from the spa
corners and the panels. These can be removed
using a drill or a screwdriver with a Philips
#2 screw bit. Every side of the spa has support
screws.
Caution
To Next Page
Loading...
