POCKET REFERENCE GUIDE — 42
DEFAULT SETTINGS
After a Clear All (Ç x), your calculator
will return to the following settings:
STORED VALUES DEFAULT VALUE
Desired Riser Height 7-1/2 INCH
Desired Tread Width 10 INCH
Floor Height 10 INCH
Rebar Spacing 18 INCH
Rebar Inset 3 INCH
Rebar Size #5 (5/8”)
Load Size 8
CU YD
Bag Size 0.666667 CU FEET
Weight per Volume 1.5 Ton Per CU YD
Block Area 128 SQ INCH
Block Length 16 INCH
Footing Area 264 SQ INCH
If you replace your battery or perform a
Full Reset* (press O, hold down x, and
press o), your calculator will return to
the following settings (in addition to those
listed above):
PREFERENCE SETTINGS DEFAULT VALUE
Fractional Resolution 1/16”
Area Display Standard
Volume Display Standard
Stairway Headroom 6
FEET 8 INCH
Exponent Off
Meter Linear Display 0.000
Decimal Degree Display 0.00°
Fractional Mode Standard
*Depressing the Reset button located above the
l key will also perform a Full Reset.
To Next Page
Loading...
Need help?
General
