26
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
May, 2023.
To wall mount the GigaSpire BLAST GM1028H
1. Find a suitable location for attaching the unit to the wall. Be mindful of the power source
and Ethernet cable requirements when determining a mounting location.
2. Using the illustrations below, mark the two screw locations on the wall, making sure the
device will remain level after mounting.
Note: If attaching to sheet rock or gypsum board, Calix recommends using a wall
anchoring system to ensure the bracket is securely attached.
3. Drill holes in the wall and install appropriate wall anchors if required.
4. Thread the screws into the wall anchors and tighten leaving a gap of about 1/8" between
the screw head and the and the back of the unit. This gap allows the u4hm wall mount
bracket to be slip fit over the mounting screws.
Before attaching the wall mount bracket to the back of the GM1028H, make sure the bracket
has locked into place as directed below.
To Next Page
Loading...
