37
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
May, 2023.
DC power (AC/DC adapter)
To connect DC power
1. Locate the 12 VDC Power Adapter.
2. Attach one end (2-pin barrel connector) to the rear of the GigaSpire system.
3. Plug the other end (3-pin) into any available 110/220 VAC wall outlet.
4. The GigaSpire begins its start-up sequence (Flashing amber LED).
GM1028H (u4hm) Power Connection
PoE power (Ethernet cable)
To connect PoE power
Note: A waterproof ethernet connector and cable are required when powered by PoE.
1. Locate the Ethernet cable supplying the power-over-Ethernet (PoE) power from the
PoE switch source.
2. Connect the Ethernet cable to the PoE Ethernet port on the rear of the GigaSpire
system.
3. The GigaSpire begins its start-up sequence (Flashing amber LED).
To Next Page
Loading...
